FACTORY LINKS Wheel Bearing Kit for HONDA TRX 250 FOURTRAX 2WD, TRX 300 FOURTRAX 2WD 1986-2000

FACTORY LINKS offers this wheel bearing for HONDA TRX 250 FOURTRAX 2WD, TRX 300 FOURTRAX 2WD 1986-2000. Each wheel spins on two bearings in the hub, separated by a spacer. Water and mud eventually damage them: play, rough spots, noise.

What is this bearing made of?

Races and balls in hardened chrome steel, 100Cr6 type, very hard and fatigue-resistant, protected by rubber seals.

• Double seal (2RS): a seal on each side, very well sealed against water and mud, essential off-road.
• Limit: slightly more drag than a metal-shielded bearing (ZZ), which spins more freely but seals far less well.
• Fitting: press or drift it in on the outer race, never hammer on the seal; keep the pressure washer away from the hubs.

Why choose FACTORY LINKS?

Factory Links, founded in 2014 by Pierre Mege between Auvergne (France) and Virginia (USA), supplies original equipment to Sherco and Electric Motion and is the official bearing and linkage partner of the FIM Hard Enduro World Championship (2026-2028).

When should you replace the bearings on your HONDA TRX 300 FOURTRAX 2WD?

Check the wheels for play at every wash with the wheel off the ground: a failing bearing can lock the wheel. Pressure washing forces water in and speeds up wear.

Specifications and fitting tips

• Manufacturer part number: AFW-H-003

Cross-Mania tip: Always replace the bearings of a wheel together and check the spacer.

Also needed with this part

• Grease : MOTUL 100 100 cl · MOTUL 100 400 g

Compatibility

Check the exact model and year of your bike in the list below before ordering.

Fits:
HONDA TRX 250 FOURTRAX 2WD 1987
HONDA TRX 250 FOURTRAX 2WD 1986
HONDA TRX 300 FOURTRAX 2WD 2000
HONDA TRX 300 FOURTRAX 2WD 1999
HONDA TRX 300 FOURTRAX 2WD 1998
HONDA TRX 300 FOURTRAX 2WD 1997
HONDA TRX 300 FOURTRAX 2WD 1996
HONDA TRX 300 FOURTRAX 2WD 1995
HONDA TRX 300 FOURTRAX 2WD 1994
HONDA TRX 300 FOURTRAX 2WD 1993