HOT RODS offers you this complete connecting rod kit for your YAMAHA 660 Grizzly /Raptor /Rhino quad. This complete package will enable you to refurbish your crankshaft, which may have some play from top to bottom. Rather than replacing the complete crankshaft, you'll often just need to change the connecting rod. This connecting rod is a cast model sold with its needle cage, anti-friction shims and crankpin. It has the same original dimensions. No adaptation is required. To change a connecting rod, you'll need a press, a balancing bench and a little patience. If you don't have the equipment to do this, you can send us your crankshaft so we can do the fitting ourselves. You can also e-mail us for a quote. All connecting rod dimensions are given below.

Technical data:

Center distance (mm) : 136.5

Short side bore (mm): 22

Connecting rod head bore (mm): 45

Bore width short side (mm): 21.97

Connecting-rod bore width (mm): 21.97

Crankpin Ø (mm): 37

Crankpin length (mm): 73.9

Short-side bearing (mm): Ring

Connecting rod head bearing (mm): 37 x 45 x 22

Washers (mm): No

Fits on :

YAMAHA YFM 660 GRIZZLY SPECIAL EDITION 4WD 2006

YAMAHA YFM 660 GRIZZLY SPECIAL EDITION 4WD 2005

YAMAHA YFM 660 GRIZZLY SPECIAL EDITION 4WD 2004

YAMAHA YFM 660 GRIZZLY SPECIAL EDITION 4WD 2003

YAMAHA YFM 660 RAPTOR 2WD 2005

YAMAHA YFM 660 RAPTOR 2WD 2004

YAMAHA YFM 660 RAPTOR 2WD 2003

YAMAHA YFM 660 RAPTOR 2WD 2002

YAMAHA YFM 660 RAPTOR LIMITED EDITION 2WD 2003

YAMAHA YXR 660 RHINO 4WD 2007

YAMAHA YXR 660 RHINO 4WD 2006

YAMAHA YXR 660 RHINO 4WD 2005

YAMAHA YXR 660 RHINO 4WD 2004

YAMAHA YXR 660 RHINO SPECIAL EDITION 4WD 2007