PROX offers you this complete connecting rod kit for your HONDA CD 200 and CM 200T. This complete package will enable you to refurbish your crankshaft, which may have some play from top to bottom. Rather than replacing the complete crankshaft, you'll often just need to change the connecting rod. This connecting rod is a cast model sold with its connecting-rod needle cage, anti-friction shims and crank pin. It has the same original dimensions. No adaptation is required. To change a connecting rod, you'll need a press, a balancing bench and a little patience. If you don't have the equipment to do this, you can send us your crankshaft so we can do the fitting ourselves. You can also e-mail us for a quote. All connecting rod dimensions are given below.

Technical data :

Center distance: 91mm

Short side bore: 14mm

Connecting rod head bore: 33mm

Short side bore width: 14mm

Connecting-rod bore width: 14mm

Crankpin Ø: 26mm

Crankpin length: 43.5mm

Short side bearing:

Connecting-rod bearing:mm

Washers (mm): No

Fits on :

HONDA CD 200

HONDA CM 200 T