HOT RODS offers you this complete connecting rod kit for your POLARIS quad. This complete package will enable you to refurbish your crankshaft, which may have some play from top to bottom. Rather than changing the complete crankshaft, you'll often just need to change the connecting rod. This connecting rod is a cast model sold with its connecting-rod needle cage, anti-friction shims and crank pin. It has the same original dimensions. No adaptation is required. To change a connecting rod, you'll need a press, a balancing bench and a little patience. If you don't have the equipment to do this, you can send us your crankshaft so we can do the fitting ourselves. Before doing so, you can contact us by e-mail for a devis.Toutes the dimensions of the connecting rod are given below.

Technical data :

Centre distance (mm): 136

Short side bore (mm): 27

Connecting rod head bore (mm): 35

Bore width short side (mm): 18

Connecting-rod bore width (mm): 18

Crank pin Ø (mm): 27

Crankpin length (mm): 60

Short-side bearing (mm): 22 x 27 x 25

Connecting-rod head bearing (mm): 27 x 35 x 18

Washers (mm): 1

Fits on :

POLARIS 1200 SLX 2001

POLARIS 1200 SLX 2000