Wössner Connecting Rod Kit - Fi for TM RACING MXF 250 2013-2017

WOSSNER offers this connecting rod kit for TM RACING MXF 250 2013-2017. The rod passes the piston’s motion to the crankshaft. Its big-end bearing spins at very high revs and eventually develops play.

Why replace the connecting rod?

The benefits:

• Remove the play that causes noise and vibration.
• Make a high-hours engine reliable again.
• Cheaper than a complete crankshaft when the flywheels are good.

Why choose WOSSNER?

Wössner has also forged its own connecting rods since 2010, with the same in-house forging expertise as its pistons.

When should you replace the connecting rod on your TM RACING MXF 250?

Unusual vibration, a deep knock that follows engine speed or play in the con-rod: the bottom end needs a rebuild.

The manufacturer publishes no hour interval for this model: have the con-rod play checked at every piston change. Cross-Mania guideline: rebuild the bottom end every 2 to 3 top-end rebuilds.

Specifications and fitting tips

• Monocylinder rod kit
• Kit contains : bearings – washers – connecting rod
• Manufacturer part number: P4065

Cross-Mania tip: Fitting requires a press and truing the crankshaft with a dial gauge. If you are not equipped, have it done by a workshop.

Also needed with this part

• Piston : PROX · WOSSNER
• 2-stroke oil : LIQUI MOLY 1 L 3065 · LIQUI MOLY 1 L 3063

Compatibility

Check the exact model and year of your bike in the list below before ordering.

Fits:
TM RACING MXF 250 2017
TM RACING MXF 250 2016
TM RACING MXF 250 2015
TM RACING MXF 250 2014
TM RACING MXF 250 2013