ALL BALLS Swing Arm Bearing Kit for POLARIS PREDATOR 500 2002-2013

ALL BALLS offers this swingarm bearing kit for POLARIS PREDATOR 500 2002-2013. The swingarm pivots on needle bearings protected by seals. Water and mud make them seize: the suspension gets stiff and play appears.

What is this bearing made of?

Races and balls in hardened chrome steel, 100Cr6 type, very hard and fatigue-resistant, protected by rubber seals.

• Double seal (2RS): a seal on each side, very well sealed against water and mud, essential off-road.
• Limit: slightly more drag than a metal-shielded bearing (ZZ), which spins more freely but seals far less well.
• Fitting: press or drift it in on the outer race, never hammer on the seal; keep the pressure washer away from the hubs.

Why choose ALL BALLS?

Complete All Balls kits: low-friction bearings and steel-spring nitrile seals, everything you need in one box.

When should you replace this part?

Side play when you rock the swingarm with the rear wheel removed, or a notchy movement: the bearings need changing.

Specifications and fitting tips

• Kit includes bearings, needle roller cages and spacers
• Refurbishes the articulation between the frame and the swing arm
• Manufacturer part number: 28-1134

Cross-Mania tip: Press out the old bearings, grease the new ones and check the swingarm pivot: if it is marked, replace it too.

Also needed with this part

• Grease : MOTUL 400 g 108664 · MOTUL 400 g 108672

Compatibility

Check the exact model and year of your bike in the list below before ordering.

Fits:
POLARIS PREDATOR 500 2013
POLARIS PREDATOR 500 2012
POLARIS PREDATOR 500 2011
POLARIS PREDATOR 500 2010
POLARIS PREDATOR 500 2009
POLARIS PREDATOR 500 2008
POLARIS PREDATOR 500 2007
POLARIS PREDATOR 500 2006
POLARIS PREDATOR 500 2005
POLARIS PREDATOR 500 2004
POLARIS PREDATOR 500 2003
POLARIS PREDATOR 500 2002