ALL BALLS Swing Arm Bearing Kit for SUZUKI LT-R 450 QUADRACER 2WD 2006-2011

ALL BALLS offers this swingarm bearing kit for SUZUKI LT-R 450 QUADRACER 2WD 2006-2011. The swingarm pivots on needle bearings protected by seals. Water and mud make them seize: the suspension gets stiff and play appears.

What is this bearing made of?

Races and balls in hardened chrome steel, 100Cr6 type, very hard and fatigue-resistant, protected by rubber seals.

• Double seal (2RS): a seal on each side, very well sealed against water and mud, essential off-road.
• Limit: slightly more drag than a metal-shielded bearing (ZZ), which spins more freely but seals far less well.
• Fitting: press or drift it in on the outer race, never hammer on the seal; keep the pressure washer away from the hubs.

Why choose ALL BALLS?

Complete All Balls kits: low-friction bearings and steel-spring nitrile seals, everything you need in one box.

When should you replace this part?

Side play when you rock the swingarm with the rear wheel removed, or a notchy movement: the bearings need changing.

Specifications and fitting tips

• Kit includes bearings, needle roller cages and spacers
• Refurbishes the articulation between the frame and the swing arm
• Manufacturer part number: 28-1172

Cross-Mania tip: Press out the old bearings, grease the new ones and check the swingarm pivot: if it is marked, replace it too.

Also needed with this part

• Grease : SHOWA 500 g · KYB

Compatibility

Check the exact model and year of your bike in the list below before ordering.

Fits:
SUZUKI LT-R 450 QUADRACER 2WD 2011
SUZUKI LT-R 450 QUADRACER 2WD 2010
SUZUKI LT-R 450 QUADRACER 2WD 2009
SUZUKI LT-R 450 QUADRACER 2WD 2008
SUZUKI LT-R 450 QUADRACER 2WD 2007
SUZUKI LT-R 450 QUADRACER 2WD 2006