ALL BALLS Swing Arm Bearing Kit for SUZUKI RM 80, RM 85 1980-2002

ALL BALLS offers this swingarm bearing kit for SUZUKI RM 80, RM 85 1980-2002. The swingarm pivots on needle bearings protected by seals. Water and mud make them seize: the suspension gets stiff and play appears.

What is this bearing made of?

Races and balls in hardened chrome steel, 100Cr6 type, very hard and fatigue-resistant, protected by rubber seals.

• Double seal (2RS): a seal on each side, very well sealed against water and mud, essential off-road.
• Limit: slightly more drag than a metal-shielded bearing (ZZ), which spins more freely but seals far less well.
• Fitting: press or drift it in on the outer race, never hammer on the seal; keep the pressure washer away from the hubs.

Why choose ALL BALLS?

Complete All Balls kits: low-friction bearings and steel-spring nitrile seals, everything you need in one box.

When should you replace this part?

Side play when you rock the swingarm with the rear wheel removed, or a notchy movement: the bearings need changing.

Specifications and fitting tips

• Swing arm bearing kit
• For a high quality renewing
• Manufacturer part number: 28-1063

Cross-Mania tip: Press out the old bearings, grease the new ones and check the swingarm pivot: if it is marked, replace it too.

Also needed with this part

• Grease : MOTUL 400 g 108664 · MOTUL 400 g 108672

Compatibility

Check the exact model and year of your bike in the list below before ordering.

Fits:
SUZUKI RM 80 2000
SUZUKI RM 80 1999
SUZUKI RM 80 1998
SUZUKI RM 80 1997
SUZUKI RM 80 1996
SUZUKI RM 80 1995
SUZUKI RM 80 1994
SUZUKI RM 80 1993
SUZUKI RM 80 1992
SUZUKI RM 80 1991
SUZUKI RM 80 1990
SUZUKI RM 80 1989
SUZUKI RM 80 1988
SUZUKI RM 80 1987
SUZUKI RM 80 1986
SUZUKI RM 80 1985
SUZUKI RM 80 1984
SUZUKI RM 80 1983
SUZUKI RM 80 1982
SUZUKI RM 80 1981
SUZUKI RM 80 1980
SUZUKI RM 85 2002