• New
    ALL BALLS Rear Independent Suspension Bearing Kit for ARCTIC CAT 400 4WD MANUAL TRANS. FIS, 500 4WD MANUAL TRANS. FIS - 50-1065
    ALL BALLS Rear Independent Suspension Bearing Kit for ARCTIC CAT 400 4WD MANUAL TRANS. FIS, 500 4WD MANUAL TRANS. FIS - 50-1065

    ALL BALLS Rear Independent Suspension Bearing Kit for ARCTIC CAT 400 4WD MANUAL TRANS. FIS, 500 4WD MANUAL TRANS. FIS - 50-1065

    Review (0)
    €145.90
    Tax Included
    En stock en nuestro proveedor, enviado en 2 a 5 días.

    An engine bearing: it lets a shaft (crank, gearbox, pump) turn without friction.

    Quantity :
    In stock

    En stock en nuestro proveedor, enviado en 2 a 5 días.

      ALL BALLS offers this engine bearing for ARCTIC CAT 400 2WD AUTO TRANS. FIS, 400 2WD MANUAL TRANS. FIS, 400 4WD AUTO TRANS. FIS, 400 4WD MANUAL TRANS. FIS, 500 4WD MANUAL TRANS. FIS 2002-2003. The engine’s shafts run on ball or roller bearings in the cases. They carry heavy loads at high revs and eventually develop play.

      What is this bearing made of?

      Races and balls (or rollers) in hardened chrome steel, 100Cr6 type: a very hard steel that withstands the fatigue of millions of engine revolutions.

      • Open bearing: unsealed, it is lubricated and cooled by the engine oil; clean oil is its best protection.
      • C3 / C4 internal clearance: slightly more clearance than normal for a hot engine’s expansion; always refit the original clearance.
      • Limit: it dislikes dust and old oil; running short of oil destroys it within minutes.

      Why choose ALL BALLS?

      Complete All Balls kits: low-friction bearings and steel-spring nitrile seals, everything you need in one box.

      When should you replace the bearings on your ARCTIC CAT 400 4WD MANUAL TRANS. FIS?

      On competition bikes the main bearings are replaced at every bottom-end rebuild, at the hours recommended by the manufacturer. With the cases open, spin each bearing by hand: the slightest rough spot means it must go.

      Specifications and fitting tips

      • Manufacturer part number: 50-1065

      Cross-Mania tip: Heat the cases to remove and fit the bearings without forcing them, and replace the oil seals at the same time.

      Also needed with this part

      Compatibility

      Check the exact model and year of your bike in the list below before ordering.

      Fits:
      ARCTIC CAT 400 2WD AUTO TRANS. FIS 2003
      ARCTIC CAT 400 2WD MANUAL TRANS. FIS 2003
      ARCTIC CAT 400 4WD AUTO TRANS. FIS 2003
      ARCTIC CAT 400 4WD MANUAL TRANS. FIS 2003
      ARCTIC CAT 400 4WD MANUAL TRANS. FIS 2002
      ARCTIC CAT 500 4WD AUTO TRANS. FIS 2003
      ARCTIC CAT 500 4WD MANUAL TRANS. FIS 2003
      ARCTIC CAT 500 4WD MANUAL TRANS. FIS 2002

      ALL BALLS
      50-1065
      4 Items

      Specific References

      No customer reviews for the moment.

      Write your review
      ALL BALLS Rear Independent Suspension Bearing Kit for ARCTIC CAT 400 4WD MANUAL TRANS. FIS, 500 4WD MANUAL TRANS. FIS - 50-1065
      ALL BALLS Rear Independent Suspension Bearing Kit for ARCTIC CAT 400 4WD MANUAL TRANS. FIS, 500 4WD MANUAL TRANS. FIS - 50-1065
      ALL BALLS Rear Independent Suspension Bearing Kit for ARCTIC CAT 400 4WD MANUAL TRANS. FIS, 500 4WD MANUAL TRANS. FIS - 50-1065
      €145.90
      Tax Included