ALL BALLS Swing Arm Bearing Kit for KTM SX 50, SX 50 PRO SENIOR LC, SX 50 SENIOR ADVENTURE 2004-2018

ALL BALLS offers this swingarm bearing kit for KTM SX 50, SX 50 PRO SENIOR LC, SX 50 SENIOR ADVENTURE 2004-2018. The swingarm pivots on needle bearings protected by seals. Water and mud make them seize: the suspension gets stiff and play appears.

What is this bearing made of?

Races and balls in hardened chrome steel, 100Cr6 type, very hard and fatigue-resistant, protected by rubber seals.

• Double seal (2RS): a seal on each side, very well sealed against water and mud, essential off-road.
• Limit: slightly more drag than a metal-shielded bearing (ZZ), which spins more freely but seals far less well.
• Fitting: press or drift it in on the outer race, never hammer on the seal; keep the pressure washer away from the hubs.

Why choose ALL BALLS?

Complete All Balls kits: low-friction bearings and steel-spring nitrile seals, everything you need in one box.

When should you replace this part?

Side play when you rock the swingarm with the rear wheel removed, or a notchy movement: the bearings need changing.

Specifications and fitting tips

• Swing arm bearing kit
• For a high quality renewing
• Manufacturer part number: 28-1170

Cross-Mania tip: Press out the old bearings, grease the new ones and check the swingarm pivot: if it is marked, replace it too.

Also needed with this part

• Grease : SHOWA 500 g · KYB

Compatibility

Check the exact model and year of your bike in the list below before ordering.

Fits:
KTM SX 50 2018
KTM SX 50 2017
KTM SX 50 2007
KTM SX 50 2006
KTM SX 50 PRO SENIOR LC 2005
KTM SX 50 PRO SENIOR LC 2004
KTM SX 50 SENIOR ADVENTURE 2007
KTM SX 50 SENIOR ADVENTURE 2006
KTM SX 50 SENIOR ADVENTURE 2005
KTM SX 50 SENIOR ADVENTURE 2004