ALL BALLS Swing Arm Bearing Kit for HONDA CR 500, XL 350, XL 600, XR 350, XR 600 1983-1987

ALL BALLS offers this swingarm bearing kit for HONDA CR 500, XL 350, XL 600, XR 350, XR 600 1983-1987. The swingarm pivots on needle bearings protected by seals. Water and mud make them seize: the suspension gets stiff and play appears.

What is this bearing made of?

Races and balls in hardened chrome steel, 100Cr6 type, very hard and fatigue-resistant, protected by rubber seals.

• Double seal (2RS): a seal on each side, very well sealed against water and mud, essential off-road.
• Limit: slightly more drag than a metal-shielded bearing (ZZ), which spins more freely but seals far less well.
• Fitting: press or drift it in on the outer race, never hammer on the seal; keep the pressure washer away from the hubs.

Why choose ALL BALLS?

Complete All Balls kits: low-friction bearings and steel-spring nitrile seals, everything you need in one box.

When should you replace this part?

Side play when you rock the swingarm with the rear wheel removed, or a notchy movement: the bearings need changing.

Specifications and fitting tips

• Swing arm bearing kit
• For a high quality renewing
• Manufacturer part number: 28-1054

Cross-Mania tip: Press out the old bearings, grease the new ones and check the swingarm pivot: if it is marked, replace it too.

Also needed with this part

• Grease : MOTUL 400 g 108664 · MOTUL 400 g 108672

Compatibility

Check the exact model and year of your bike in the list below before ordering.

Fits:
HONDA CR 500 1987
HONDA CR 500 1986
HONDA CR 500 1985
HONDA CR 500 1984
HONDA XL 350 1985
HONDA XL 350 1984
HONDA XL 600 1987
HONDA XL 600 1986
HONDA XL 600 1985
HONDA XL 600 1984
HONDA XL 600 1983
HONDA XL 600 RM 1986
HONDA XR 350 1985
HONDA XR 350 1984
HONDA XR 350 1983
HONDA XR 500 1984
HONDA XR 500 1983
HONDA XR 600 1987
HONDA XR 600 1986
HONDA XR 600 1985