ART Rear Propeller Shaft Can Am for CAN-AM OUTLANDER 650, OUTLANDER 650 EFI XT, OUTLANDER 650 XT 2006-2012

ART offers this drive shaft for CAN-AM OUTLANDER 650, OUTLANDER 650 EFI XT, OUTLANDER 650 XT 2006-2012. On a 4x4 quad or a side-by-side, the drive shaft is the shaft that links the differential to the wheel and carries engine power to it.

Why replace the drive shaft?

The benefits:

• Get back a drivetrain free of clicks and vibration, even under load and on full lock.
• A complete shaft is swapped in one go: no need to strip and regrease the joints one by one.
• A part made for your model that fits in place of the original without modification.

When should you replace this part?

Clicking when steering or accelerating, vibration, grease flung onto the rim or a split boot: the joint is wearing, replace the drive shaft before it breaks.

Specifications and fitting tips

• Position: Rear
• Manufacturer part number: PAPRS-8024

Cross-Mania tip: Grease the splines, check the shaft is clipped into the differential by pulling on it by hand, then tighten the hub nut to the specified torque and lock it (new split pin or staking, depending on the model).

Compatibility

Check the exact model and year of your bike in the list below before ordering.

Fits:
CAN-AM OUTLANDER 650 2012
CAN-AM OUTLANDER 650 2011
CAN-AM OUTLANDER 650 2010
CAN-AM OUTLANDER 650 2009
CAN-AM OUTLANDER 650 2008
CAN-AM OUTLANDER 650 2007
CAN-AM OUTLANDER 650 2006
CAN-AM OUTLANDER 650 EFI XT 2012
CAN-AM OUTLANDER 650 EFI XT 2011
CAN-AM OUTLANDER 650 EFI XT 2010
CAN-AM OUTLANDER 650 EFI XT 2009
CAN-AM OUTLANDER 650 XT 2008
CAN-AM OUTLANDER 650 XT 2007
CAN-AM OUTLANDER 650 XT 2006