WOSSNER complete crankshaft for HUSQVARNA TC 125 from 2014 to 2015

WOSSNER offers this complete crankshaft for HUSQVARNA TC 125 from 2014 to 2015. The crankshaft is the engine’s main shaft: the rod turns it and it drives the clutch and gearbox.

Why a complete crankshaft?

The benefits:

• Ready to fit, no specialist needed to press in a rod.
• Bottom end renewed in one go.
• Often cheaper than rebuilding a badly worn crank.

Why choose WOSSNER?

Wössner has also forged its own connecting rods since 2010, with the same in-house forging expertise as its pistons.

When should you replace the crankshaft on your HUSQVARNA TC 125?

Unusual vibration, a deep knock that follows engine speed or play in the con-rod: the bottom end needs a rebuild.

The manufacturer publishes no hour interval for this model: have the con-rod play checked at every piston change. Cross-Mania guideline: rebuild the bottom end every 2 to 3 top-end rebuilds.

Specifications and fitting tips

• Includes crankshaft and connecting rod assembly plus small end bearing
• Standard replacement crankshaft assembly unless otherwise stated

Cross-Mania tip: Take the opportunity, with the cases open, to replace the crankshaft bearings and oil seals.

Also needed with this part

• Crankshaft bearings and seals : see the selection
• Complete engine gasket kit : CENTAURO · TECNIUM
• Piston : WOSSNER 8220DA · WOSSNER 8174DA
• 2-stroke oil : LIQUI MOLY 1 L 3065 · LIQUI MOLY 1 L 3063

Compatibility

Check the exact model and year of your bike in the list below before ordering.

Fits:
HUSQVARNA TC 125 2015
HUSQVARNA TC 125 2014