Wössner Connecting Rod Kit for SUZUKI LT-R 450 QUADRACER 2WD 2006-2011

WOSSNER offers this connecting rod kit for SUZUKI LT-R 450 QUADRACER 2WD 2006-2011. The rod passes the piston’s motion to the crankshaft. Its big-end bearing spins at very high revs and eventually develops play.

Why replace the connecting rod?

The benefits:

• Remove the play that causes noise and vibration.
• Make a high-hours engine reliable again.
• Cheaper than a complete crankshaft when the flywheels are good.

Why choose WOSSNER?

Wössner has also forged its own connecting rods since 2010, with the same in-house forging expertise as its pistons.

When should you replace the connecting rod on your SUZUKI LT-R 450 QUADRACER 2WD?

Unusual vibration, a deep knock that follows engine speed or play in the con-rod: the bottom end needs a rebuild.

The manufacturer publishes no hour interval for this model: have the con-rod play checked at every piston change. Cross-Mania guideline: rebuild the bottom end every 2 to 3 top-end rebuilds.

Specifications and fitting tips

• Monocylinder rod kit
• Kit contains : bearings – washers – connecting rod
• Manufacturer part number: P4011

Cross-Mania tip: Fitting requires a press and truing the crankshaft with a dial gauge. If you are not equipped, have it done by a workshop.

Also needed with this part

• 4-stroke engine oil : MOTUL 10W50 · LIQUI MOLY 10W40 1 L

Compatibility

Check the exact model and year of your bike in the list below before ordering.

Fits:
SUZUKI LT-R 450 QUADRACER 2WD 2011
SUZUKI LT-R 450 QUADRACER 2WD 2010
SUZUKI LT-R 450 QUADRACER 2WD 2009
SUZUKI LT-R 450 QUADRACER 2WD 2008
SUZUKI LT-R 450 QUADRACER 2WD 2007
SUZUKI LT-R 450 QUADRACER 2WD 2006