HOT RODS Hollow Crank Pin 22x51mm for KAWASAKI KX 125 1979-2002

HOT RODS offers this crank pin for KAWASAKI KX 125 1979-2002. The crankshaft of an off-road engine is often made of two flywheels joined by a pin, the crank pin.

Why replace the crank pin?

The benefits:

• The crank pin wears along with the needle bearing: replacing it gives a big end with no play again.
• An alternative to a complete crankshaft: you keep your original flywheels.
• A healthy bottom end again, without vibration or knocking.

Why choose HOT RODS?

Hot Rods, the bottom-end specialist since 1993: crankshafts, rods, bearings and seals for a complete rebuild.

When should you replace this part?

Up-and-down play in the connecting rod at top dead centre, a marked, pitted or blued crank pin surface, a knock from the bottom end: rebuild the crank with a new crank pin.

Specifications and fitting tips

• Manufacturer part number: P106

Cross-Mania tip: Have the crankshaft pressed and trued by a properly equipped workshop (press, V-blocks, dial gauge), replace the needle bearing and thrust washers at the same time, then check the connecting rod side play.

Compatibility

Check the exact model and year of your bike in the list below before ordering.

Fits:
KAWASAKI KX 125 2002
KAWASAKI KX 125 2001
KAWASAKI KX 125 2000
KAWASAKI KX 125 1999
KAWASAKI KX 125 1998
KAWASAKI KX 125 1997
KAWASAKI KX 125 1996
KAWASAKI KX 125 1995
KAWASAKI KX 125 1994
KAWASAKI KX 125 1993
KAWASAKI KX 125 1992
KAWASAKI KX 125 1991
KAWASAKI KX 125 1990
KAWASAKI KX 125 1989
KAWASAKI KX 125 1988
KAWASAKI KX 125 1987
KAWASAKI KX 125 1986
KAWASAKI KX 125 1985
KAWASAKI KX 125 1984
KAWASAKI KX 125 1983
KAWASAKI KX 125 1982
KAWASAKI KX 125 1981
KAWASAKI KX 125 1980
KAWASAKI KX 125 1979