HOT RODS offers you this complete connecting rod kit for your HODNA CR 500cc. This complete kit will allow you to refurbish your crankshaft that may have some play from top to bottom. Rather than changing the entire crankshaft, you will often just need to change the connecting rod. This connecting rod is a cast model sold with its needle cage, its anti-friction shims and its crank pin. It has the same original dimensions. No adaptation is required. To change a connecting rod, you will need a press, a balancing bench and a little patience. If you don't have the material to do that, you can send us your crankshaft so that we can do the assembly ourselves. You can contact us first by e-mail to get a quote. All the dimensions of the connecting rod are given below.

Technical data :

Big End I.D. connecting rod: 34mm

Width of connecting rod head: 19.750mm

Center to Center Connecting Rod: 144mm

Small end connecting rod I.D.: 25mm

Connecting rod width: 23.980mm

Engine type: 2 stroke

Includes connecting rod, crank, crank bearing, wrist bearing and thrust washers

Spindle length: 67.500mm

THK washer: 1.500mm

Fits on :

HONDA CR 500 R (PE02) 2001

HONDA CR 500 R (PE02) 2000

HONDA CR 500 R (PE02) 1999

HONDA CR 500 R (PE02) 1998

HONDA CR 500 R (PE02) 1997

HONDA CR 500 R (PE02) 1996

HONDA CR 500 R (PE02) 1995

HONDA CR 500 R (PE02) 1994

HONDA CR 500 R (PE02) 1993

HONDA CR 500 R (PE02) 1992

HONDA CR 500 R (PE02) 1991

HONDA CR 500 R (PE02) 1990

HONDA CR 500 R (PE02) 1989

HONDA CR 500 R (PE02) 1988

HONDA CR 500 R (PE02) 1987