HOT RODS offers you this complete connecting rod kit for your HODNA CR 125cc. This complete kit will allow you to refurbish your crankshaft that may have some play from top to bottom. Rather than changing the entire crankshaft, you will often just need to change the connecting rod. This connecting rod is a cast model sold with its needle cage, its anti-friction shims and its crank pin. It has the same original dimensions. No adaptation is required. To change a connecting rod, you will need a press, a balancing bench and a little patience. If you don't have the material to do that, you can send us your crankshaft so that we can do the assembly ourselves. You can contact us first by e-mail to get a quote. All the dimensions of the connecting rod are given below.

Technical data :

Big End connecting rod I.D.28mm

Width of connecting rod head 16 mm

Connecting rod center to center: 104mm

Small end connecting rod I.D.: 18mm

Width of small end of connecting rod: 16mm

Engine type: 2 stroke

Includes connecting rod, crank, crank bearing, wrist bearing and thrust washers

Spindle length: 54mm

EP washer: 1mm

Fits on :

HONDA CR 125 R (JE01) 1987

HONDA CR 125 R (JE01) 1986

HONDA CR 125 R (JE01) 1985