PROX Crankshaft Bearing Ø30x62x16 - NJ206ECP-2 for SHERCO SEF 250, SEF 300 2016-2023

PROX offers this engine bearing for SHERCO SEF 250, SEF 300 2016-2023. The engine’s shafts run on ball or roller bearings in the cases. They carry heavy loads at high revs and eventually develop play.

What is this bearing made of?

Races and balls (or rollers) in hardened chrome steel, 100Cr6 type: a very hard steel that withstands the fatigue of millions of engine revolutions.

• Open bearing: unsealed, it is lubricated and cooled by the engine oil; clean oil is its best protection.
• C3 / C4 internal clearance: slightly more clearance than normal for a hot engine’s expansion; always refit the original clearance.
• Limit: it dislikes dust and old oil; running short of oil destroys it within minutes.

Why choose PROX?

ProX uses Koyo or NTN bearings, largely made in Japan in OEM factories, with the original internal clearance (C3 / C4).

When should you replace the bearings on your SHERCO SEF 300?

On competition bikes the main bearings are replaced at every bottom-end rebuild, at the hours recommended by the manufacturer. With the cases open, spin each bearing by hand: the slightest rough spot means it must go.

Specifications and fitting tips

• Packing: by unit
• Manufacturer part number: 23.NJ206ECP-2

Cross-Mania tip: Heat the cases to remove and fit the bearings without forcing them, and replace the oil seals at the same time.

Also needed with this part

• Complete engine gasket kit : CENTAURO 912A002FL · CENTAURO 912A003FL
• 4-stroke engine oil : LIQUI MOLY 10W40 1 L · MOTUL 10W50

Compatibility

Check the exact model and year of your bike in the list below before ordering.

Fits:
SHERCO SEF 250 2023
SHERCO SEF 250 2022
SHERCO SEF 250 2021
SHERCO SEF 250 2020
SHERCO SEF 250 2019
SHERCO SEF 250 2018
SHERCO SEF 250 2017
SHERCO SEF 300 2023
SHERCO SEF 300 2022
SHERCO SEF 300 2021
SHERCO SEF 300 2020
SHERCO SEF 300 2019
SHERCO SEF 300 2018
SHERCO SEF 300 2017
SHERCO SEF 300 2016