- New
ITALKIT Connecting Rod Kit for HONDA CRF 250 2004-2010
€152.25
Tax Included
The connecting rod links the piston to the crankshaft and turns the push of every combustion into rotation.
ITALKIT connecting rod kit for HONDA CRF 250 from 2004 to 2010.
On HONDA CRF 250 from 2004 to 2010, the ITALKIT BC.5090R connecting rod kit fits in place of the original part. Between the piston and the crankshaft, the connecting rod takes every combustion and every climb through the revs. Replacing the rod, crank pin and bearing in time prevents engine failure.
Specifications
- Brand: ITALKIT
- Manufacturer part number: BC.5090R
- Engine: 4-stroke
When to replace it?
- Vertical play at the big end at top dead centre.
- Side play out of tolerance, signs of overheating (bluing).
- Vibration and dull noise from the bottom end.
During a bottom end rebuild, at the intervals in the service manual, and without delay as soon as play appears at the big end.
Fitting tips
- Replacing a connecting rod means pressing the crankshaft apart and then realigning it: with a dial indicator, you check the run-out, i.e. the deviation in rotation measured at the end of the shaft, which must stay within a few hundredths of a millimetre at most. Leave this job to a properly equipped workshop if you don't have a press and a truing stand.
- Replace the crankshaft bearings and oil seals at the same time.
- Check the big-end side play after assembly.
- Close up the engine with a complete engine gasket kit and tighten to the manufacturer's torque.
- Check the gearbox bearings, then fill up with fresh oil and fit a new spark plug.
Why ITALKIT?
ITALKIT is a Spanish manufacturer of engine parts for small-displacement machines: cylinders, pistons, crankshafts, reed valves and spare parts in several sizes. The brand is very active in 50cc racing, especially in Spain.
Spare parts and items to plan
- Crankshaft bearings and seals : see the selection
- Complete engine gasket kit : VERTEX · ITALKIT
- Gearbox bearings : HOT RODS TBK0008 · HOT RODS TBK0092
- 4-stroke engine oil : LIQUI MOLY 10W40 1 L · MOTUL 10W50
- Spark plug : NGK R0409B · NGK R0451B
Frequently asked questions
Can I fit the connecting rod myself?
Yes, if you have a press and a crankshaft truing stand; otherwise, an engine workshop can do it for you.
What else should I plan for?
The crankshaft bearing and seal kit, the complete engine gasket kit, the gearbox bearings if required, engine oil and a spark plug.
Compatibility
Check the exact model and year of your bike in the list below before ordering.
Fits:
HONDA CRF 250 2010
HONDA CRF 250 2009
HONDA CRF 250 2008
HONDA CRF 250 2007
HONDA CRF 250 2006
HONDA CRF 250 2005
HONDA CRF 250 2004
Click on your bike to see all compatible parts.
No customer reviews for the moment.
The connecting rod links the piston to the crankshaft and turns the push of every combustion into rotation.
ITALKIT connecting rod kit for HONDA CRF 250 from 2004 to 2010.
ITALKIT Connecting Rod Kit for HONDA CRF 250 2004-2010
€152.25
Tax Included