HOT RODS Hollow Crank Pin 38X65mm for HONDA XL 600, XL 600 RM, XR 600 1983-2000

HOT RODS offers this crank pin for HONDA XL 600, XL 600 RM, XR 600 1983-2000. The crankshaft of an off-road engine is often made of two flywheels joined by a pin, the crank pin.

Why replace the crank pin?

The benefits:

• The crank pin wears along with the needle bearing: replacing it gives a big end with no play again.
• An alternative to a complete crankshaft: you keep your original flywheels.
• A healthy bottom end again, without vibration or knocking.

Why choose HOT RODS?

Hot Rods, the bottom-end specialist since 1993: crankshafts, rods, bearings and seals for a complete rebuild.

When should you replace this part?

Up-and-down play in the connecting rod at top dead centre, a marked, pitted or blued crank pin surface, a knock from the bottom end: rebuild the crank with a new crank pin.

Specifications and fitting tips

• Manufacturer part number: P146

Cross-Mania tip: Have the crankshaft pressed and trued by a properly equipped workshop (press, V-blocks, dial gauge), replace the needle bearing and thrust washers at the same time, then check the connecting rod side play.

Compatibility

Check the exact model and year of your bike in the list below before ordering.

Fits:
HONDA XL 600 1987
HONDA XL 600 1986
HONDA XL 600 1985
HONDA XL 600 1984
HONDA XL 600 1983
HONDA XL 600 RM 1986
HONDA XR 600 2000
HONDA XR 600 1999
HONDA XR 600 1998
HONDA XR 600 1997
HONDA XR 600 1996
HONDA XR 600 1995
HONDA XR 600 1994
HONDA XR 600 1993
HONDA XR 600 1992
HONDA XR 600 1991
HONDA XR 600 1990
HONDA XR 600 1989
HONDA XR 600 1988
HONDA XR 600 1987
HONDA XR 600 1986
HONDA XR 600 1985