HOT RODS Balancer Shaft Reconditioning Kit for HONDA TRX 400 EX SPORTRAX 2WD 1999-2008

HOT RODS offers this engine bearing for HONDA TRX 400 EX SPORTRAX 2WD 1999-2008. The engine’s shafts run on ball or roller bearings in the cases. They carry heavy loads at high revs and eventually develop play.

What is this bearing made of?

Races and balls (or rollers) in hardened chrome steel, 100Cr6 type: a very hard steel that withstands the fatigue of millions of engine revolutions.

• Open bearing: unsealed, it is lubricated and cooled by the engine oil; clean oil is its best protection.
• C3 / C4 internal clearance: slightly more clearance than normal for a hot engine’s expansion; always refit the original clearance.
• Limit: it dislikes dust and old oil; running short of oil destroys it within minutes.

Why choose HOT RODS?

Hot Rods, the bottom-end specialist since 1993: crankshafts, rods, bearings and seals for a complete rebuild.

When should you replace the bearings on your HONDA TRX 400 EX SPORTRAX 2WD?

On competition bikes the main bearings are replaced at every bottom-end rebuild, at the hours recommended by the manufacturer. With the cases open, spin each bearing by hand: the slightest rough spot means it must go.

Specifications and fitting tips

• Manufacturer part number: BBK0026

Cross-Mania tip: Heat the cases to remove and fit the bearings without forcing them, and replace the oil seals at the same time.

Also needed with this part

• 4-stroke engine oil : MOTUL 10W50 · LIQUI MOLY 10W40 1 L

Compatibility

Check the exact model and year of your bike in the list below before ordering.

Fits:
HONDA TRX 400 EX SPORTRAX 2WD 2008
HONDA TRX 400 EX SPORTRAX 2WD 2007
HONDA TRX 400 EX SPORTRAX 2WD 2006
HONDA TRX 400 EX SPORTRAX 2WD 2005
HONDA TRX 400 EX SPORTRAX 2WD 2004
HONDA TRX 400 EX SPORTRAX 2WD 2003
HONDA TRX 400 EX SPORTRAX 2WD 2002
HONDA TRX 400 EX SPORTRAX 2WD 2001
HONDA TRX 400 EX SPORTRAX 2WD 2000
HONDA TRX 400 EX SPORTRAX 2WD 1999