HOT RODS Hollow Crank Pin 22X57mm for YAMAHA YFS 200 BLASTER 2WD 1990-2007

HOT RODS offers this crank pin for YAMAHA YFS 200 BLASTER 2WD 1990-2007. The crankshaft of an off-road engine is often made of two flywheels joined by a pin, the crank pin.

Why replace the crank pin?

The benefits:

• The crank pin wears along with the needle bearing: replacing it gives a big end with no play again.
• An alternative to a complete crankshaft: you keep your original flywheels.
• A healthy bottom end again, without vibration or knocking.

Why choose HOT RODS?

Hot Rods, the bottom-end specialist since 1993: crankshafts, rods, bearings and seals for a complete rebuild.

When should you replace this part?

Up-and-down play in the connecting rod at top dead centre, a marked, pitted or blued crank pin surface, a knock from the bottom end: rebuild the crank with a new crank pin.

Specifications and fitting tips

• Manufacturer part number: P111

Cross-Mania tip: Have the crankshaft pressed and trued by a properly equipped workshop (press, V-blocks, dial gauge), replace the needle bearing and thrust washers at the same time, then check the connecting rod side play.

Compatibility

Check the exact model and year of your bike in the list below before ordering.

Fits:
YAMAHA YFS 200 BLASTER 2WD 2007
YAMAHA YFS 200 BLASTER 2WD 2006
YAMAHA YFS 200 BLASTER 2WD 2005
YAMAHA YFS 200 BLASTER 2WD 2004
YAMAHA YFS 200 BLASTER 2WD 2003
YAMAHA YFS 200 BLASTER 2WD 2002
YAMAHA YFS 200 BLASTER 2WD 2001
YAMAHA YFS 200 BLASTER 2WD 2000
YAMAHA YFS 200 BLASTER 2WD 1999
YAMAHA YFS 200 BLASTER 2WD 1998
YAMAHA YFS 200 BLASTER 2WD 1997
YAMAHA YFS 200 BLASTER 2WD 1996
YAMAHA YFS 200 BLASTER 2WD 1995
YAMAHA YFS 200 BLASTER 2WD 1994
YAMAHA YFS 200 BLASTER 2WD 1993
YAMAHA YFS 200 BLASTER 2WD 1992
YAMAHA YFS 200 BLASTER 2WD 1991
YAMAHA YFS 200 BLASTER 2WD 1990