Wössner Connecting Rod Kit for KAWASAKI KFX 450 2008-2014

WOSSNER offers this connecting rod kit for KAWASAKI KFX 450 2008-2014. The rod passes the piston’s motion to the crankshaft. Its big-end bearing spins at very high revs and eventually develops play.

Why replace the connecting rod?

The benefits:

• Remove the play that causes noise and vibration.
• Make a high-hours engine reliable again.
• Cheaper than a complete crankshaft when the flywheels are good.

Why choose WOSSNER?

Wössner has also forged its own connecting rods since 2010, with the same in-house forging expertise as its pistons.

When should you replace the connecting rod on your KAWASAKI KFX 450?

Unusual vibration, a deep knock that follows engine speed or play in the con-rod: the bottom end needs a rebuild.

The manufacturer publishes no hour interval for this model: have the con-rod play checked at every piston change. Cross-Mania guideline: rebuild the bottom end every 2 to 3 top-end rebuilds.

Specifications and fitting tips

• Monocylinder rod kit
• Kit contains : bearings – washers – connecting rod
• Manufacturer part number: P4019

Cross-Mania tip: Fitting requires a press and truing the crankshaft with a dial gauge. If you are not equipped, have it done by a workshop.

Also needed with this part

• 4-stroke engine oil : LIQUI MOLY 10W40 1 L · MOTUL 10W50

Compatibility

Check the exact model and year of your bike in the list below before ordering.

Fits:
KAWASAKI KFX 450 2014
KAWASAKI KFX 450 2013
KAWASAKI KFX 450 2012
KAWASAKI KFX 450 2011
KAWASAKI KFX 450 2010
KAWASAKI KFX 450 2009
KAWASAKI KFX 450 2008