MIKUNI Carburetor Repair Kit VM30-34

MIKUNI offers this carburettor repair kit. The carburettor prepares the air-fuel mixture the engine needs, through small passages and very precise parts.

Why a repair kit?

The benefits:

• All the wear parts in one order: no second strip-down for a forgotten seal.
• A sealed carburettor no longer leaks onto the hot engine or in the van.
• Much cheaper than a new carburettor when the body is in good condition.

Why choose MIKUNI?

Mikuni, founded in Japan in 1923, is known for supplying carburettors to many major Japanese manufacturers; its TMX38 is original equipment on Yamaha YZ125s and KTM 150 and 250 two-strokes: Mikuni jets, needles and slides are the original parts for these carburettors.

When should you replace this part?

Fuel leaking around the bowl, a carburettor that overflows, an idle that hunts or hard starting despite a correct setting: the seals and float needle are tired, rebuild the carburettor.

Specifications and fitting tips

• Manufacturer part number: 3030480

Cross-Mania tip: Strip it on a clean surface, noting where each part goes and how many turns the mixture screw is out, clean the passages with carb cleaner and compressed air (never with wire), then check the float height before closing the bowl.

Compatibility

Universal part: check the dimensions given before ordering.