VENHILL Front Brake Hose Stainless Steel for HONDA CR 125, CR 250, CR 500 1984-1987

VENHILL offers this braided brake hose for HONDA CR 125, CR 250, CR 500 1984-1987. When you pull the lever or press the pedal, brake fluid is pushed through the hose to the caliper, which squeezes the pads onto the disc.

Why fit a braided brake hose?

The benefits:

• A firmer lever: the effort you put in really reaches the pads.
• Braking that is easy to modulate and does not go soft when the brakes get hot.
• The stainless braid stands up to rubbing and flying debris better than a rubber hose.

Why choose VENHILL?

Venhill was founded in 1970 in Dorking, England, by trials and motocross rider Chris Ventris; its cables and hoses are made in-house, and every Powerhose line (stainless braid, minimum burst pressure 12,000 psi) is pressure-tested under water before dispatch.

When should you replace the brake hose on your HONDA CR 125?

A spongy lever, or a cracked, bulging or weeping hose: the hose must be replaced.

Specifications and fitting tips

• Position: Front
• Smooth bore DuPont PTFE hosing for heat resistance
• Marine grade stainless braiding to help eliminate expansion
• Manufacturer part number: H02-1-019/P

Cross-Mania tip: Use new banjo washers, refill with fresh fluid (the DOT grade shown on the reservoir) and bleed carefully.

Also needed with this part

• Brake fluid : MOTUL 500 ml 109452 · MOTUL 500 ml 101666
• Brake pads : TOURMAX · GALFER

Compatibility

Check the exact model and year of your bike in the list below before ordering.

Fits:
HONDA CR 125 1987
HONDA CR 125 1986
HONDA CR 125 1985
HONDA CR 125 1984
HONDA CR 250 1987
HONDA CR 250 1986
HONDA CR 250 1985
HONDA CR 250 1984
HONDA CR 500 1987
HONDA CR 500 1986
HONDA CR 500 1985
HONDA CR 500 1984