Lower a-arm bearing KIT for LT-R450 2006-07 PIVOT WORKS for SUZUKI LT-R 450 QUADRACER 2WD 2006-2011

PIVOT WORKS offers this engine bearing for SUZUKI LT-R 450 QUADRACER 2WD 2006-2011. The engine’s shafts run on ball or roller bearings in the cases. They carry heavy loads at high revs and eventually develop play.

What is this bearing made of?

Races and balls (or rollers) in hardened chrome steel, 100Cr6 type: a very hard steel that withstands the fatigue of millions of engine revolutions.

• Open bearing: unsealed, it is lubricated and cooled by the engine oil; clean oil is its best protection.
• C3 / C4 internal clearance: slightly more clearance than normal for a hot engine’s expansion; always refit the original clearance.
• Limit: it dislikes dust and old oil; running short of oil destroys it within minutes.

Why choose PIVOT WORKS?

Pivot Works kits, sold by the American All Balls Racing group, use hardened NTN, NSK or Koyo bearings from original-equipment bearing suppliers, supplied pre-greased with their seals; every kit carries the Pivot Works limited lifetime warranty.

When should you replace the bearings on your SUZUKI LT-R 450 QUADRACER 2WD?

On competition bikes the main bearings are replaced at every bottom-end rebuild, at the hours recommended by the manufacturer. With the cases open, spin each bearing by hand: the slightest rough spot means it must go.

Specifications and fitting tips

• Manufacturer part number: PWAAK-S08-400L

Cross-Mania tip: Heat the cases to remove and fit the bearings without forcing them, and replace the oil seals at the same time.

Also needed with this part

• 4-stroke engine oil : LIQUI MOLY 10W40 1 L · MOTUL 10W50

Compatibility

Check the exact model and year of your bike in the list below before ordering.

Fits:
SUZUKI LT-R 450 QUADRACER 2WD 2011
SUZUKI LT-R 450 QUADRACER 2WD 2010
SUZUKI LT-R 450 QUADRACER 2WD 2009
SUZUKI LT-R 450 QUADRACER 2WD 2008
SUZUKI LT-R 450 QUADRACER 2WD 2007
SUZUKI LT-R 450 QUADRACER 2WD 2006