ITALKIT offers you this complete connecting rod kit for your HONDA and GAS GAS. This complete package will enable you to refurbish your crankshaft, which may have some play from top to bottom. Rather than changing the complete crankshaft, you'll often just need to change the connecting rod. This connecting rod is a cast model sold with its connecting-rod needle cage, anti-friction shims and crank pin. It has the same original dimensions. No adaptation is required. To change a connecting rod, you'll need a press, a balancing bench and a little patience. If you don't have the equipment to do this, you can send us your crankshaft so we can do the fitting ourselves. You can also e-mail us for a quote. All connecting rod dimensions are given below.

Technical data :

Center distance (mm): 125.4

Connecting-rod bore (mm): 22

Connecting-rod bore (mm): 31

Connecting-rod bore width (mm) :

Connecting-rod bore width (mm): 17

Crankpin diameter (mm): 24

Crankpin length (mm): 59.5

Connecting-rod bushing (mm): 18 x 22 x 22

Connecting-rod bushing (mm): 24 x 31 x 17

Connecting-rod washers (mm): 0.85/1.25

Fits on :

HONDA CR 250 R 1984

HONDA CR 250 R 1985

HONDA CR 250 R 1986

HONDA CR 250 R 1987

HONDA CR 250 R 1988

HONDA CR 250 R 1989

HONDA CR 250 R 1990

HONDA CR 250 R 1991

HONDA CR 250 R 1992

HONDA CR 250 R 1993

HONDA CR 250 R 1994

HONDA CR 250 R 1995

HONDA CR 250 R 1996

HONDA CR 250 R 1997

HONDA CR 250 R 1998

HONDA CR 250 R 1999

HONDA CR 250 R 2000

HONDA CR 250 R 2001

HONDA TRX 250 R

HONDA ATC 250 R

GAS GAS 250

GAS GAS 300